AnsweredAssumed Answered

PI Points update failure after using a different config file.

Question asked by EthanCao on Jul 13, 2017
Latest reply on Jul 14, 2017 by jyi

Hi, I am collecting data from a meter. My UFL config file is attached. Initially I made a mistake in the config file and current change c2 and c3 are assigned with timestamp variable, i.e.,

'''

Cnt_2=["*,*,*,*,*,(*),*,*,*,*,*,*,*,*,*,*"]

StoreInPI("EKM01_c2", ,NOW(),Timestamp, , )

Cnt_3=["*,*,*,*,*,*,(*),*,*,*,*,*,*,*,*,*"]

StoreInPI("EKM01_c3", ,NOW(),Timestamp, , )

'''

which is of course unideal. After fixing it to the following,

'''

Cnt_2=["*,*,*,*,*,(*),*,*,*,*,*,*,*,*,*,*"]

StoreInPI("EKM01_c2", ,NOW(),Cnt_2, , )

Cnt_3=["*,*,*,*,*,*,(*),*,*,*,*,*,*,*,*,*"]

StoreInPI("EKM01_c3", ,NOW(),Cnt_3, , )

'''

 

The "EKM01_c2" and "EKM02_c3" can no longer be updated. As shown in the figure attached, other values are successfully updated while "c2" and "c3" display timestamp value I initially assigned. I tried to restart the connector server, config a new data source but nothing is changed. I am a bit confused as I believe updating config file should be straightforward and I have little clue as to what could possibly go wrong. Any hint and advice are welcomed and appreciated! Thank you.

Attachments

Outcomes