AnsweredAssumed Answered

Problem with data changing after snapshot

Question asked by jirvine on Nov 7, 2017
Latest reply on Nov 8, 2017 by gachen

I have a point that keeps changing it's data AFTER it's written. The data comes in like it should, and using the archive editor I can see the numbers range from .4956535 - .4959574. After a few minutes the numbers that were there all change to a static .6103702.

 

I can't figure out why the data keeps changing.

Compression is turned off.

Step is off.

Span is set to 10000 which is high but I don't think would affect it.

Exception Deviation is set to 0.

It's a Float16 with display digits set to 5.

 

 

So, anyone have a logical explanation why it's happening? I'm sure there's a setting I'm not familiar with I just can't figure it out.

Outcomes