AnsweredAssumed Answered

How do I make a gauge show zero in the center of range?

Question asked by t65green on Aug 1, 2019
Latest reply on Aug 1, 2019 by Todd.McQuiston

I'm converting from Process Book to Vision.

In Process Book, even in the Process Book that is converted to vision, the bar chart for a PI Tag value that has a range of -20 to +20 indicates only a center-line when the value is near/at zero.

When I try to create a vertical/horizontal gauge in Vision, when the value is near/at zero, the bar is shaded from -20 to 0, which is more of an indication that it's at -20 rather than zero.  

 

Is there any way to correct this?

I'd assume it's not an issue with the PI tag setup since it's working correctly on the other display?

Outcomes