AnsweredAssumed Answered

Use StartTime in Endtrigger eventframe

Question asked by Sanne on Jun 11, 2020

Hi,

 

I would like to use the StartTime of my event in the EndTrigger of my event as shown in the figure below. I am creating an eventframe as warning to replace an asset. The event should be stopped when the asset is replaced. I would like to do this by comparing the Placementdate with the starttime of the event. However, it seems impossible to get the starttime in the endtrigger. Do you know another way to stop the event based on the placementdate?

 

I cannot do this by using things like NumOfChanges as the placementdate attribute is read from a table which is updated every few hours but in which case the value of the attribute is not always updated.

 

Outcomes