Hello,

Im very new to AF and was hoping someone can assit me around which function and function code i need to use to get the required Steady State output.

I need to calculate the 'Steady State' temperature of a Generator bearing pad.

"Steady State' temp is defined as the average temp for the hours the MW value has been greater than 10mwh for at least 6 hours.

Any assistance around which function and the code i need to use to get this outout would be much appreciated.

The temp and MW values are each a PI tag.

Thanks

Dean

Hi Dean,

I am not sure if I understood it correctly, but I prepared an example. If it is not exactly what are you looking for, please elaborate on it.

I created 2 AF Attributes (MW and Temp), and analysis like below.

Hope it helps!

Regards,

Piotr