I am trying to setup 2 computers with failover to one PI server, but I can not see the other computers when I click "browse" for "Failover ID# to the other instance".
Both computers are delivering data to my PI server..
My problem was that the Point Source was diffrent on all interfaces. I didn't know that they was supposed to be the same.Now all my point source = A.
In order for the interface to recognize that there is a similar interface on the other node, it should be created and saved in the MDB. Can you put a screenshot for the other node?
Check also the interface list in
PI SMT--> Interface list
Also, I see you have COLD selected. Be aware that COLD will result in some data loss when fail-over occurs.
As Hachem stated, it looks for other interfaces that match on PS, Interface ID and Phase.
In general, only those interfaces will appear, that have already been configured with ICU.
(Once they are configured in ICU, then they have information in the MDB under %OSI -> Interfaces -> <machine name>, which is what Hachem has asked you to check for)
I have the same issue. On Interface node1 I see both Interfaces and on Interface node 2 just the local Interface.Both Interfaces are in
PISMT-->Module Databse->%OSI->Interfaces. Is there any other idea?
I realized that one interface is on version 2.3.11 and the other is on version 22.214.171.124
May be this is the reason. Can you put both interfaces on the same version?
Also both interfaces should have same ID, I see ID is 1 and 2 so not the same.
Good idea, I will upgrate after I have swiched to the new Interface node ( at the moment it's running just with test tags).
Retrieving data ...